mixingboard3.1.spin

Share this object
<

Overview

  • Object ID : 2392 (2013-04-11)
  • Author : Larry W. Schoolcraft | added by Archiver
  • Content :
  • Microcontroller :
  • Language :
  • Category :
  • Licence :

Content

Gives an eight value readout to a 50K ohm potientiometer utilizing the Parallax P8X32A Quick Start Development Board, Parallax 2x16 Serial LCD (optional), & using the FullDuplexSerial.spin object in the Propellar Library (optional). As you turn the Pot, LED's(P16-P23) light up/ shutdown in ascending/descending order along with the value "Velocity" on the display increasing/decreasing in decimal and binary. If you are not using the display, just run the object as is and it should work just fine.

Added Note on 8/29/2012: The Value for resistor R2 is incorrect as shown on schematic diagram, the correct value should be 20k ohms.

Also needed:

  • 50K Ohm Potientiometer
  • An Assortment of Resistors and Capacitors(Values shown in
  • schematic daigram at the top of the object.)
  • 1 LED
  • +5V Supply for LCD display(optional)

Pro's:

  • Gives a pretty acurate reading

Con's:

  • Uses 10 I/O pins.
  • Only gives Eight Values

Downloads  
Zip archive download

Leave a Reply