3 I/O Pin Hitatchi compatible LCD driver

Warning message

The Propeller Object Exchange system is decommissioned and replaced with a GitHub repository to house the same existing and future Propeller objects. As of 12/5/2019, this site is read-only. You can continue to browse and download objects from here for a limited time; however, please begin using the Parallax Propeller repository for future reference.
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0
Request group membership
By: created: 2011-07-17 | updated: 2013-06-17


My initial hack at interfacing a Power Tip PC2004LRF LCD display to the prop chip. Uses only 3 I/O lines; clock, data, E. 
The three methods in the object are 1) init the display, 2) send commands to the LCD, and 3) send data to be displayed. To display data, requires sending either sequential data or an address command then a data out. See the test fixture included here.
This is one dot oh, feel free to use, abuse, or improve it. Any feedback is welcomed, whether heeded shall remain open.
Made schematic correction to show MR* pulled up to +5V
Original File Upload
Binary Data HI_LCD_CNT_2.spin13.17 KB
Binary Data PC2004LRF_test.spin7.74 KB