ESC Motor Control Demo

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0
Request group membership
By: Cluso99 , created: 2013-04-05 | updated: 2013-04-05


A simple program to drive an ESC to control a Brushless Motor from the Prop using the PC keyboard to vary the speed.
Values of 0/12.5/25/37.5/50/62.5/75/87.5/100% can be set which corresponds to a signal on time of 1ms (OFF) to 2ms (100%) with an off time of 20mS.
This code is an extension of Gavin's Single_Servo_Assembler program in the OBEX.
Original File Upload
Binary Data ESC_Motor_Control_Demo.spin23.33 KB